![]() Using double faced tape or Velcro, attached the Oznium receiver box to the top of the crash bar about a foot left of center.The other pair can be clipped off or ignored. Only one set pair of the yellow and white wires is needed. Crimp a female spade connector on the ends of the yellow (12v output) and white (ground) leads of the Oznium receiver box.Crimp a male spade connector on the ends of the red (12v input) and black (ground) leads on the Oznium receiver box.Power on and off with special effects (dimming, strobe, and heartbeat) using the Oznium controller All other steps are the same as the on/off with headlights procedure. Power On/Off with the Daytime Running Lightsįollow the same instructions as powering the lighted T from the headlights, but with one exception – attach the Posi-tap to the orange wire with black stripe in the headlamp wire plug bundle. With testing complete, snap the nosecone back into place on the front of the car, taking care to thread the leads from the T in front of the chrome piece to which the top clip of the nose cone attaches, taking care not to crimp or otherwise stress any of the connections. If not test all of your connections to make sure they are correct and secure. Do the same with the black connection from the ground.īefore snapping the nose cone back into place, turn on the headlights. Place the nose cone near the front of the car just under the crash bar and carefully connect the red female spade connector from the headlight connection to the red male connector on the lighted T and arch. Loosen one of the several 10mm bolts connected to the aluminum frame under the frunk plastic piece you removed and attach the U spade connector and tighten down the bolt. To complete the power and ground connection, crimp a female spade connector on the end of a 2’ long piece of black hook up wire and then crimp a fork spade connector large enough to fit on 10mm bolt on the other end. This will connect to the male connector on the lighted T and arch. Next run attach a female spade connector to end of the red lead from the Posi-tap. ![]() Attach a 3 foot piece of the red hook-up wire to the connection end of the Posi-tap then screw it back on to the Posi-tap assembly. Following the instructions for the Posi-tap (see video: ) screw on the tap side to the red wire with white stripe. Take a Posi-tap connector of appropriate size. Gently pull that wire apart from the surrounding wires. That wire provides 12v power to the headlamps and will be tapped to provide 12v power to the lighted T and arch. It’s the first wire closest to the nosecone in the lower row. In the exposed area under the liner locate the wire connector plugged in to the back of the headlamp assembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |